Free 640-802 Demo Download

Free demo for CWNP CWNP PW0-104 exam (Wireless LAN Administration Exam). You can check out the interface, question quality and usability of our practice exams

Free Download 640-802 Exam Pdf Demo
Free Download 640-802 Exam iEngine Demo

　
　
Exam : CWNP PW0-104
Title : Wireless LAN Administration Exam

1. What word describes the bending of an RF signal as it passes between mediums of different density?
A. Diffraction
B. Reflection
C. Refraction
D. Diffusion
E. Scattering
Answer: C

2. Given: A WLAN transmitter that emits a 200 mW signal is connected to a cable with a 9 dB loss.
if the cable is connected to an antenna with a 10 dBi gain, what is the EIRP at the antenna element?
A. 50 mW
B. 250 mW
C. 500 mW
D. 750 mW
E. 1000 mW
Answer: B

3. What factor is NOT taken into account when calculating the System Operating Margin of a point-to-point outdoor WLAN bridge link?
A. Operating frequency
B. Tx antenna gain
C. Tx power
D. Rx cable loss
E. Antenna height
F. Rx sensitivity
G. Distance
Answer: E

4. What causes an excessively high Voltage Standing Wave Ratio (VSWR) in an 8011 WLAN?
A. An impedance mismatch between devices in series with the main RF signal
B. Reflected DC voltage on the main RF signal line
C. Refracted RF signal peaks along the main signal path
D. Crosstalk (inductance) between adjacent conductors
Answer: A

5. What factors affect the distance that an RF signal can be effectively received?
A. Transmitting station’s antenna type
B. Receiving station’s radio sensitivity
C. Fresnel zone blockage
D. Power over Ethernet (PoE) usage
E. Antenna connector type
F. Distance between access points
Answer: ABC

6. Given: ABC Company’s network administrator was just asked to install a 5 GHz OFDM bridge link between two buildings. He connected a WLAN bridge with a 50-ohm output to a 50-ohm RF coaxial cable. He connected the other end of the RF coaxial cable to a 25-ohm, 6 dBi Yagi antenna.
What is the maximum VSWR between the WLAN bridge and the Yagi antenna?
A. 1.0:1
B. 1.1:1
C. 1.2:1
D. 1.5:1
E. 2.0:1
F. 1.0:2
Answer: E

7. As an RF wave propagates through space, the wave front experiences natural expansion. What is the detrimental effect of this expansion in a WLAN system?
A. Linear Diffusion Loss
B. Signal Attenuation
C. Transmission Obfuscation
D. Fresnel Zone Thinning
E. Azimuth Inflation
Answer: B

8. Given: Return Loss is the decrease of forward energy in a system because some of the power is being reflected back toward the transmitter.
What can cause a high return loss in an RF transmission system?
A. A Voltage Standing Wave Ratio (VSWR) of 1.5:1
B. An impedance mismatch between devices in the RF system
C. Cross-polarization of the RF signal as it passes through the RF system
D. The use of multiple connector types in the RF system (e.g. N-type and SMA-type)
E. Low output power at the transmitter and use of a high-gain antenna
Answer: B